My Essentia table is at its lowest position, but the digital display does not show the correct height

Issue: 

  • My Essentia table is at its lowest position, but the digital display does not show the correct height

Possible Causes:

  • The control box may not be set with the correct initial settings. 

Possible Solutions:

Note: Programmable Switch is required for troubleshooting. If your table is equipped with the Standard Switch with no display, please contact FIELDSERVICE@WORKRITEERGO.COM or call Workrite Technical Support at 1-800-959-9675 option-2.

  1. Press the DOWN button to move table to its lowest position.
  2. Press the S button (display shows S-).
  3. Press the DOWN button for 5 seconds until the display starts flashing.
  4. Use the UP or DOWN buttons to change display height.
  5. Press the S button to confirm the new lowest height shown on the display.